Boot (trunk) rubber which fits to the body of the vehicle. This is a pinch weld rubber seal that pushes over the metal lip on the body of the boot opening. Please note: The opening edge must be cleaned of any dirt before fitting the pinch weld. Start fitting the pinch weld with the flap of rubber facing out, at the lock striker (middle of the opening) and push on it around the opening until you get near the starting point, carefully cut the rubber and then the pinch weld with a sharp blade approximately 10mm longer and glue the ends together then push the pinch weld back on. Hint: If the vehicle has been repainted you may have to adjust the striker in/down, so the tailgate seals all the way around on the boot/ tailgate. On sedans adjust the striker so the boot lid closes level with the ¼ panels. This product suits Ford Cortina MK 2 Standard, Deluxe, Super, GT Sedan Fitted with 4 cylinder 1.2 L, 1.5 L engine.
