reid tailshaft housing, aluminum, gm, powerglide, roller bearing type, each

The Reid Racing, Inc. tailshaft housings are designed to fit both the REID Superglide and the stock GM Powerglide transmissions. 5 times stronger than stock, yet weighs only 4-1/2 pounds

• 
  

  Bolt in replacement – length and crossmember mounting flange is exactly the same as stock

  
  


• 
  

  Double lip seal

  
  


• 
  

  Relocated vent puts an end to the problem of trans fluid spraying out of breather

  
  


• 
  

  Completely pre-assembled

  
  


• 
  

  Includes a hardware kit with everything you need to bolt it on

  
  

Special Note: No speedometer cable provision is supplied.

This model uses a needle rolling bearing to transfer maximum horsepower. A modified stock driveshaft yoke or special hardened undersize yoke is required (*see yokes section)